Surveyor Robotics Journal
Surveyor Corporation home page
Subscribe to a syndicated RSS feed.
Archives
November 2008
October 2008
September 2008
August 2008
September 2008
August 2008
July 2008
June 2008
May 2008
April 2008
March 2008
February 2008
January 2008
December 2007
November 2007
October 2007
September 2007
August 2007
July 2007
June 2007
May 2007
April 2007
March 2007
February 2007
January 2007
December 2006
November 2006
October 2006
September 2006
August 2006
July 2006
June 2006
May 2006
April 2006
March 2006
Februray 2006
January 2006
Mon, 17 Mar 2008
robotic blimp (YARB 1.0) update - sensors added
The blimp now have some additional sensors - a pair of Maxbotics EZ0 ultrasonic ranging modules and a Honeywell HMC6532 I2C compass. Also, the camera module now points downward about 30-degrees via a simple extender. The camera angle is pretty good now - the wide angle lens has a field-of-view of approx 120-degrees, so the bottom of the frame captures the scenary almost directly below.
At the moment, the sensor data is unfiltered, which allows us to get an idea of how much variation there might be. The ultrasonic data is pretty solid - the forward looking readings bounce around a bit, but the download readings are fairly consistent. However, I think we will change to a narrower beam module - probably the EZ1. Also, it would be nice to have a couple of side-looking modules to enable some degree of mapping capability.
The compass is less consistent, and it turns out that we're getting magnetic field interference from the motors when they are running. At the time I recorded the video clip below, I wasn't paying attention to the readings, but subsequent tests show that the readings are varying by as much as 15-degrees when the motors are powered. Either we will have to move the compass, or add some compensation in software.
Here's a snapshot of the gondola with the additional sensors -
The plan is to make changes in the sensors to clean up the data, and then to write a script using the onboard C interpreter to let the blimp wander around on its own, perhaps following a course based on heading. After that, we will add some logic to use the camera to lock onto an object and follow it around while maintaining altitude and avoiding collision - that will be a bit more challenging.
Here's some video captured from yesterday's test session. The caption overlay shows heading, forward distance and height above ground in inches.
Posted Mon, 17 Mar 2008 21:35 | HTML Link | see additional stories ...