Hi,
 
I have a SRV1 cam, that doesn't react any more. The startup-light sequence is as it should be but I can't connect to the cam. I've connected the cam by an FTDI-3.3V cable and an external power supply (3.3V). The cable is working (did a loopback on rx and tx), but I get no answer from the cam in the terminal. When I try Autobaud, I get the error  
Timeout. Check BMODE pins and reset the processor before trying again
But reset doesn't help. Pin17 is connected to gnd.
 
Can someone give me a hint what to do???
 
Best regards, Ozzy

I'm using an FTDI-3.3V cable as well, if I can be of any help.  But you had the cable working before?  
 
I have to be careful to plug mine in correctly!  
 
Alan  KM6VV

So, I testet it with a second cam and this works well! Any further ideas?